• The coating is using specific ceramic compound loads for application directly over surfaces minimum temps of 250°C (482°F) and up to 600°C (1112°F).
• It Is designed to block and hold the interior temperature on the surface and reduce heat transfer loss to ambient.

• As the high-temp insulation coat for surfaces greater than 250°C, over hot pipes, tanks, and valves
• To hold heat on the surface of the pipe, valve, etc.
• As a system to block conductive and convective heat transfer
• Applied when a hot system cannot be shut down

CAUTION: Do not expose Part B to open flame as solvent used to allow silicones to blend faster. After Parts A and B are blended, product is non-flammable for use in spraying direct to hot surfaces reaching 650°C
For specific instructions on surface preparation, mixing and application, please refer to the HPC®-HT Coating Application Instruction Sheet available upon request. If HPC®-HT is applied over hot exterior surfaces, and can be over-coated, Super Therm®, Rust Grip®, Enamo Grip or HPC system topcoat can be used according to what is needed.

HPC®-HT must be completely dry before applying topcoat. HPC® Multi-Mesh Membrane System or high-temp mesh can be used on hot pipes when continuous cycles cause movement, and where continuous impact caused by workers handling the hot pipe is unavoidable. PRIME FIRST: Use HT Primer over the hot surface after cleaning off hot pipe surface from debris. Spray on a thin coat (3mm/120mils) to seal the surface and give an adhesive layer for the insulation coating (HPC-HT). See HT Primer tech sheet.